2020 BMW X1
1 recall and 13 owner complaints on record for this model year.
Check a specific vehicle
This page describes the model. To see how one particular car is equipped, and whether its identifier is valid, decode its VIN.
Decode a VIN1 recall and 13 owner complaints on record for this model year.
This page describes the model. To see how one particular car is equipped, and whether its identifier is valid, decode its VIN.
Decode a VINAlmost all of this describes the model year, not the individual car. Nothing here can tell you about this vehicle’s mileage, accidents or ownership — no identifier encodes those.
BMW of North America, LLC (BMW) is recalling certain 2020 X1 xDrive28i, X1 sDrive28i, X2 xDrive28i and X2 sDrive28i, 2020 MINI Clubman Cooper S All4, 2021 MINI Hardtop 2 Door (Cooper, Cooper S, John Cooper Works and Cooper S E) and MINI Hardtop 4 Door (Cooper and Cooper S) vehicles. Due to a problem with the rollover sensor within the air bag control unit, in the event of a rollover crash, the head air bag, seat belt pretensioners and other safety systems, may not activate.
Remedy: BMW will notify owners, and dealers will replace the air bag control unit, free of charge. The recall began July 17, 2020. Owners may contact BMW customer service at 1-800-525-7417 or MINI customer service at 1-866-825-1525.
Published by model year, not by VIN — may not apply to this vehicle, or may already have been done. Confirm with a dealer.
The seatbelts in the second row may not have been manufactured correctly and could cause the car-sensitivity sensors to fail. This could reduce the protective effect of the seatbelts and lead to injuries. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The seat belts of the car were not manufactured correctly. In the event of a collision or accident, the restraint function of the seat belts may be reduced and may not provide the necessary protection. As a result, there may be an increased risk of injury. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The cell modules in the vehicles concerned were not produced in accordance with the specifications, which may cause the module frame to fail. This may lead to a shutdown of the high-voltage system and fire. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The material used for the B-pillar reinforcement plates is inadequate. This can alter the crash characteristics, leading to an increased risk of injuries in the event of an accident. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The propellant in the inflator of the driver airbag may deteriorate over time. If the airbags deploy, it could result in fragments of the inflator injuring the vehicle's occupants. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The driver airbag inflator may malfunction due to long-term degradation. In this case, if the airbag is deployed in an accident, the internal pressure in the inflator may be too high. The inflator could burst. Metal fragments may cause injuries. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The hollow shaft of the servomotor was not welded correctly. The weld may not be able to withstand high braking pressure build-up and may break. In this case, the reduced braking performance requires greater force and the braking distance may increase. In addition, the ABS and DSC brake control systems are not assisted. This increases the risk of an accident. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The propellant within the integrated inflator of driver airbags can deteriorate during time. If the airbag deploys, it could result in fragments from the inflator casing injuring the vehicle’s occupants. The product does not comply with the Regulation on the approval and market surveillance of Motor Vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The propellant in the driver airbag may deteriorate over time. If the airbags deploy, it could result in fragments from the inflator injuring the vehicle's occupants. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The propellant in the driver airbag may deteriorate over time. If the airbags deploy, it could result in fragments from the inflator injuring the vehicle's occupants. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The front left seat's height adjustment mechanism may have been incorrectly riveted, potentially compromising the seat's structural integrity. In an accident, this could have a negative impact on the restraint system and increase the risk of injuries. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The seat recliner adjuster may not be correctly welded, which could cause the backrest not to lock. If it doesn't lock, the seatback might not stay secure in a collision, increasing the risk of injury. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The integrated braking system could be compromised, which could lead to an unexpected failure of the hydraulic braking assistance, thereby requiring greater pressure on the brake pedal. This can result in a longer braking distance, as well as failure of the Anti-lock Braking System (ABS) and the Dynamic Stability Control (DSC), increasing the risk of an accident. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
Matched on brand and model name — Safety Gate publishes no VIN. Check the production dates, and quote the recall code to a dealer.
THE TRUNK COVER HAS PIECES OF EITHER PLEXI OR FIBER GLASS THAT GETS INTO YOUR SKIN. I HAVE GOTTEN TINY SHARDS OF THE GLASS IN MY SKIN AND IT BECOME UNIMAGINABLY PAINFUL AND IT IS VERY HARD TO GET OUT OF THE SKIN.
I was in a front end crash at approximately 30 to 35 miles per hour and airbags did not deploy nor did the seatbelt lock. My chest hit the steering wheel and I was transported by EMS to hospital. Nothing was broken. I had a bruise upper right chest but my pain is in my sternum which is not visibly bruised but is very sore and my activity and mobility is impaired. My radiator was busted and car was towed by local police department to tow yard which is where it is right now. Soon to be moved to a repair center as the police report becomes available. It has not been inspected at this point. Just want to make the issue known.
I had a series of concerning incidents with my car. The trunk door was getting stuck halfway, but I was able to close it after turning on the engine. I also encountered a malfunction error on the backup camera, a Drive Train warning sign, and the car alarm going off by itself. The most alarming issue was when the car started smoking and then caught fire underneath the hood near the driver's side windshield. Thankfully, my father and I were able to put out the flames with a water hose before calling 911 to report the incident to the fire department. The car is considered a total per Geico Insurance.
The contact owns a 2020 BMW X1. The contact stated that while driving 75 MPH, the vehicle suddenly decelerated to 10 MPH. There was no warning light illuminated. During the failure, the messages, "Chassis Stabilization: Drive Moderately," "Collision Warning System Malfunction," "Pedestrian Warning Reduced," and "Drivetrain: Continued Driving Possible" were displayed. The vehicle was pulled over into a remote emergency lane and driven 10 miles to an exit. The vehicle was towed to the dealer, where it was diagnosed with a short circuit to ground at the throttle body. The contact was informed that the throttle ground wire and controller needed to be replaced. The vehicle was not yet repaired. The manufacturer was notified of the failure. The failure mileage was 67,000.
The fuel tank got punctured on the freeway causing the car to lose power. The problem seems that BMW plastic fuel tank is located on the right side at the bottom of the car so any stone or particle on the freeway can puncture the plastic tank from the bottom causing no fuel and the car losing power. Seems like that is problem with design and BMW is aware of it since the new models of the car starting 2023 have an extra underbody protection for the fuel tank which is missing on the previous year models.
Wastegate actuator turbo failure. Causes sudden loss of power to engine. Turbo function impacted. Drivetrain malfunction warning on dashboard. No prior warning sent. Problem with wastegate has been confirmed by Independent Service Center. Found similar issue with BMW E-Series Model 530e xdrive sedan Production dates 2/22/17-6/18/20 which extended warranty to 15 yr/150000 miles for same part. [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
it all started with the Battery and Powertrain and lound Loud niose from under my vehicle and my rear tail light code default. service forgetting to put the clamps back on i took the vehicle back from service and drove over 200 miles when the code for the above mention malfuntion appeared again they admitted the negilence of the service team...from that point on they my car was in and out of service for weeks at a time from September 2023 until Febuary 2024. I endlessly tried to resovle reimbursement and prove my vehicle was unsafe to drive and manufacture defects. i also consulted corporate several times submitting claim and nothing was esculated or followed up. listed below are the issues I have experienced on sevaral trips in my vehicle.I am in panic state each and every time I drive this vehicle. the codes and invetigation numbers are associted with the creen shots I obtained with the service machanics virtual video of my visits: 10228427 B220222 10177616 B010419 10176377 B610520 10228428 B120723 1024907 B611305 10178993 B160319 My Request would be a Brand Buy Back or my Rights for claim under Indiana lemon law consumer act.
I got my BMW X1 in December of 2020 and currently has 21,000 miles. I've notice unusual wear and tear on the driver side seatbelt so I brought it into the dealer but all they said was that it needs to be replaced. I don't think this is a normal wear and tear because as I've said, I only drove this vehicle for 21,000 miles. The tear is expanding and I believe this can be a serious safety issue during an accident or sudden stops. I was concerned if this was an issue to similar vehicles or if it's just my vehicle.
Check Engine light checked at dealership revealed Fuel in the NVLD System! They had to replace the NVLD, Charcoal canister, and the Tank vent valve. They accused me of overfilling my fuel tank! I am 100% certain that I NEVER overfill fuel whatsoever. I am afraid this may cause other drivers to ignore the problem resulting in vehicle fires! Please investigate further or ask for repair frequency of this problem from BMW. I owned a BMW for almost 20 years and never experienced this problem! Thanks
The vehicle’s sunroof exploded spontaneously. This occured on an elevated expressway with no access above the vehicle. There was no physical impact to the vehicle. There were no visible warning signs. The sunroof shattered into small shards.
On 7/1/22, my Vehicle Alert came on advising that the front brake pads need replacement and to schedule an appointment within 1,000 miles. I called the same day to schedule an appointment with my local dealer. However, the next available date was on 7/13/22. I specifically requested an earlier date, but that was the only available slot they had. I brought my vehicle in on 7/13/22 (alert now says schedule an appointment within 800 miles so i had driven 200 miles) and was given an estimate to replace the front brake pads. On the same day, i get a call from the dealer service advisor that the front rotors also needs replacement as they were damaged due to continued driving with worn down brake pads. They also advised the engine mount was cracked and leaking. My safety concern is that the alert should have came on sooner as I called to schedule an appointment the same day the alert came on but the only available time for almost two weeks later. There should have been a more urgent alert (i.e. replace within 50 miles) as I would have then made separate arrangements immediately. Alternatively, the alert should come on much earlier in the brake pads' wear detection. Instead, I was unknowingly driving my vehicle with dangerously damaged rotors due to the false sense of safety as the alert said schedule appointment within the next 1000 miles and I had only driven 200 miles. This put not only my safety at risk but others on the road as well should my brakes have failed. A crash would have been more dangerous in light of the cracked engine mount and leak. I understand brakes are wear and tear and customer pay but i feel that the alert system design and logic needs to be looked at as non-savvy drivers rely on them to make appointments accordingly.
On Sept 8, 2021, on I-5, North of Marysville, WA, a truck threw a rock through the lower radiator of our X1. We lost all coolant and car was hauled to BMW, Seattle on 9/9/21. On 9/10 service rep Josh Logan advised: "We confirmed that it does not come with a guard, but when you order a new part, that does come in conjunction." and that: "no warranty coverage, as it does not cover damages, so you would have to go through your insurance for that one." We did so and USAA covered the amount above the $1000 deductible. It is unacceptable that the need for the rock shield was clearly a known condition, yet when damage occurred due to it not being installed from new, that the replacement was not covered under warranty. First Name: [XXX] Last Name: [XXX] Email Address: [XXX] Phone Number: [XXX] Preferred Contact Method: Email Address: [XXX] City: [XXX] State: [XXX] ZIP Code: [XXX] Own a BMW: Yes Year: 2020 Series: X Model: X1 xDrive28i VIN: [XXX] Month Purchased: November Year Purchased: 2020 INFORMATION Redacted PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6).
On Sept 8, 2021, on I-5, North of Marysville, WA, a truck threw a rock through the lower radiator of our X1. We were very lucky that we stopped and found the coolant running out. Otherwise the engine might have seized at highway speed , causing an accident. We lost all coolant and car was hauled to BMW, Seattle on 9/9/21. On 9/10 service rep Josh Logan advised: "We confirmed that it does not come with a guard, but when you order a new part, that does come in conjunction." and that: "no warranty coverage, as it does not cover damages, so you would have to go through your insurance for that one." We did so and USAA covered the amount above the $1000 deductible. It is unacceptable that the need for the rock shield was clearly a known condition, yet when damage occurred due to it not being installed from new, that the replacement was not covered under warranty.
Filed by owners of this model year and unverified by NHTSA — one person’s account, not an established fact.