1 Rückruf und 3 Halterbeschwerden für dieses Modelljahr erfasst.
Diese Seite beschreibt das Modell. Um zu sehen, wie ein einzelnes Fahrzeug ausgestattet ist und ob seine Kennung gültig ist, entschlüsseln Sie die FIN.
FIN entschlüsselnFast alles hiervon beschreibt das Modelljahr, nicht das einzelne Fahrzeug. Nichts davon sagt etwas über Laufleistung, Unfälle oder Eigentum dieses Autos — keine Kennung kodiert das.
We had snow this afternoon and my wife drove the car home from work. We live on a private road and have a steep driveway. I had her park the car in the road while I plowed the driveway. There was only 1-2” of snow on the ground. My wife existed the car. It appeared to be off and in park meaning the engine was not running and the car sat still on a grade. In hindsight, I should have had her set the park brake. My wife went down to her house taking her key with her. I was plowing the driveway. The car had been sitting still on the road for at least 15 minutes. When I was plowing, I had the other key in my pocket. When I got next to the car while still operating my plow, I noticed the taillights came on. Next, the car began rolling down the hill on its own. Nobody was in the car. I was chasing the car. I noted the rear tires were rolling. They were not sliding. The car contained to roll forward then veered towards the side of the road that has a steep ditch. The car then slide sideways down the embankment and stopped at the bottom of the hill. Fortunately, the car did not rollover. Had it been dry and now snow, I think it would have rolled over sideways due to the steep pitch but instead it slid in the snow. I think I was lucky and there is no significant damage but I have not fully retrieved the car out of the ditch yet. I suspect the car was in the start stop mode and possibly my wife did not put into park before exiting the car but this could be easily done since it has the push buttons shifter and the engine was off. Not sure if this is what happened, it’s just speculation. This could have been much more serious if this happened with other people or cars around.
Vehicle has intermittent raw fuel odor and shaking at idle. BMW dealership test‑drove and scanned but refused further diagnostics under warranty because the issue could not be duplicated. BMW NA case opened. Fuel odor is a fire hazard and shaking at idle is a stall risk.
The contact called on behalf of her daughter, who owns a 2024 BMW X4. The contact stated that while attempting to leave a parking lot driving 5 MPH, there was a loud glass shattering sound coming from the sunroof of the vehicle. The contact immediately pulled over and inspected the vehicle and became aware that the sunroof glass had shattered. The vehicle was taken to a local dealer where it was diagnosed, and the contact was informed that the sunroof glass needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 22,755.
Von Haltern dieses Modelljahrs eingereicht und von der NHTSA nicht geprüft — die Schilderung einer Person, keine feststehende Tatsache.
BMW of North America, LLC (BMW) is recalling certain 2024 2 Series Coupe (230i), 330i, X3 sDrive30i, X3 xDrive30i, X3 M40i, and X4 xDrive30i, X4 M40i vehicles. The steering gear may not have been tightened properly, which can allow it to loosen.
Abhilfe: Dealers will replace the steering gear, free of charge. Owner notification letters were mailed January 11, 2024. Owners may contact BMW customer service at 1-800-525-7417.
Nach Modelljahr veröffentlicht, nicht nach FIN — betrifft dieses Fahrzeug möglicherweise nicht oder wurde bereits erledigt. Beim Händler bestätigen.
Water may come into contact with the starter relay and gradually cause corrosion. This could affect the electrical connection inside the relay and make the engine difficult to start. It may also result in a short circuit and could cause the starter to overheat leading to a fire when the vehicle is in motion or when it is parked with the ignition off. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The RSW22 starter with reinforced water tightness (RWT) may experience increased abrasion of the magnetic contact, causing deposits to build up at the lowest point inside the relay. These deposits may increase relay contact resistance, leading to starting failures or short circuits. If a short circuit occurs, either when attempting to start the vehicle or while driving due to vibration-related movement of the deposits, it could cause a thermal event and increase the risk of fire. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The failure concerns the RSW22 starter, type RWT (reinforced for watertightness). Increased abrasion of the magnetic contact can lead to the formation of deposits at the lowest point of the relay interior. This in turn can increase the resistance of the relay contact, causing accidental ignition or even short circuits, possibly leading to a thermal reaction and fire. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The failure concerns the RSW22 starter, type RWT (reinforced for watertightness). Increased abrasion of the magnetic contact can lead to the formation of deposits at the lowest point of the relay interior. This in turn can increase the resistance of the relay contact, causing accidental ignition or even short circuits, possibly leading to a thermal reaction and fire. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The failure concerns the RSW22 starter, type RWT (reinforced for watertightness). Increased abrasion of the magnetic contact can lead to the formation of deposits at the lowest point of the relay interior. This in turn can increase the resistance of the relay contact, causing accidental ignition or even short circuits, possibly leading to a thermal reaction and fire. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The screw connection of the servo unit on the gear rack casing of the steering system may be faulty. This could cause the steering system to fail and become blocked, increasing the risk of an accident. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The propellant in the driver airbag may deteriorate over time. If the airbags deploy, it could result in fragments from the inflator injuring the vehicle's occupants. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
A seam on the inflator housing of the driver airbag may not have been correctly welded. In case of accident, when the airbag is deployed, the inflator can burst, releasing metal parts which could cause injuries. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
Due to a manufacturing error, the weld seam of the integrated transmission control unit (ITCU) may not have been correctly executed. As a result, transmission oil could leak into the ITCU, causing it to fail. This may lead to transmission seizure, increasing the risk of an accident. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
Abgeglichen über Marke und Modellname — Safety Gate veröffentlicht keine FIN. Prüfen Sie die Produktionsdaten und nennen Sie dem Händler den Rückrufcode.