1 richiamo e 411 segnalazioni di proprietari registrati per questo anno modello.
Questa pagina descrive il modello. Per sapere come è equipaggiata una singola auto e se il suo identificativo è valido, decodifica il VIN.
Decodifica un VINQuasi tutto questo riguarda l’anno modello, non la singola auto. Nulla qui può dirti chilometraggio, incidenti o proprietà di questo veicolo: nessun identificativo li codifica.
FOR ABOUT THE LAST FIVE THOUSAND MILES, MY STEERING HAS DEVELOPED THE DANGEROUS STEERING CONDITION( DESCRIBED BY LITERALLY HUNDREDS OF OWNERS IN BLOGS AND VARIOUS POSTINGS-JUST DO A SEARCH FOR "Z4 STEERING PROBLEM") THAT EXISTS IN 2003-2005 BMW Z4 ROADSTERS. AT FIRST, THE PROBLEM OCCURRED ONLY ON VERY HOT DAYS (AS DESCRIBED MY MANY OTHERS). NOW, IT AFFECTS ALL ASPECTS OF DRIVING, MAKING THE VEHICLE VERY DIFFICULT TO CONTROL. STEERING REQUIRES CONSTANT CORRECTION FROM LEFT TO RIGHT AND DOES NOT RETURN TO CENTER. I HAVE REPLACED TIRES TWICE AND HAD SEVERAL ALIGNMENTS WITH NO EFFECT. IF EVER THERE WAS A SAFETY ISSUE THAT WOULD WARRANT A RECALL THIS IS IT. THE DEAD STEERING DESCRIBED IS MOST EVIDENT AT HIGHWAY SPEEDS (50-70MPH)
WATER GETS INTO THE BATTERY COMPARTMENT THROUGH THE RUBBER GROMMET THAT CARRIES THE MAIN BATTERY CABLE FROM THE TRUNK TO THE FRONT OF THE CAR. THE BATTERY COMPARTMENT IS A WELL THAT ALSO HOUSES THE CAR STEREO AMPLIFIER. AMPLIFIER WAS SITTING IN ABOUT 2 INCHES OF WATER CAUSING THE CIRCUIT BOARD TO SHORT OUT AND CATCH ON FIRE. *TR
THE STEERING IS THE ONLY PROBLEM BUT YOUR WEB SITE INSISTS ON MY SELECTING AT LEAST 3 AFFECTED PARTS. IN ANY CASE, THE STEERING RECENTLY BECAME JERKY AND NOTCHY WHILE DRIVING. AFTER SEVERAL DAYS OF THIS, I TOOK IT MY LOCAL FOREIGN CAR REPAIR SPECIALIST AND THEY DIAGNOSED A PROBLEM WITH THE ELECTRONIC POWER STEERING. ULTIMATELY, THEY REPLACED THE ENTIRE STEERING COLUMN AT A COST TO ME OF $4100. THIS WAS A VERY UNSAFE CONDITION MAKING MY CONTROL OF STEERING TENUOUS AT BEST AND ONE THAT YOU HAVE RECEIVED NUMEROUS COMPLAINTS ABOUT. *TR
Twice this month, while operating the vehicle, the power steering completely stopped functioning, causing the vehicle to be almost uncontrollable. No prior warning light. When I purchased the vehicle in 2018, the same problem occurred and the dealer replaced the steering column under warranty. In researching online I find that this is a common problem with this model. I am surprised to find that there is no recall notice for what is a major safety concern.
Power steering wheel went out of power during a trip at about 70mph. Yellow light at the dashboard went ON then so, car became imposible to drive or so.
The electric steering gets sticky when very often. It feels locked in its position and requires extra force to unstick, once its past the sticking point it over corrects and causes the vehicle to swerve. This failure seems to be quite common and is well known. It seems to be a manufacturing defect inside the electric steering column. I believe it should be investigated by NHTSA. The last time it happened my car went off onto the soft shoulder. The manufacturer should repair the steering. It’s a widely known issue.
When driving the steering is loose or sticky. The problem gets worse when the weather is warm. Sometimes it’s hard to keep the car driving in a straight path. This is scary and dangerous. His occurs whenever the car is driven. Other z4 drivers are having the same problem.
The steering sticks, in warmer weather, at freeway speeds. Continuously trying to unstick the steering wheel, with the possibility of overcorrecting, at freeway speeds, could present a safety hazard. Yes, the alignment company recognized the problem during their post-alignment test drive. The vehicle has not been inspected by "manufacturer, police, or insurance representatives." No warning lamps/lights/messages on dash. However, if you google 2004 BMW with sticky steering, you will find NUMEROUS accounts of this happening to other owners of similar vehicles (specifically 2003-2005 Z4).
The electric steering gets sticky when hot. It feels locked in its position and requires extra force to unstick, once its past the sticking point it over corrects and causes the vehicle to swerve. This failure seems to be quite common and is well known. It seems to be a manufacturing defect inside the electric steering column. I believe it has already been investigated by NHTSA but a recall has not yet been called to protect the consumer. This failure only happens when it is hot or the heater is on in the car, there is no warning before it occurs. Thank you for your attention in this matter. Please help by re-investigating this common failure.
The steering is sticky, like the steering system is locking up. It isn't smooth but instead very jerky, and requires serious effort to manage. It is becoming dangerous and is very unsafe. I have seen a lot of complaints on the internet and can not believe this isn't a recall item!
Component or system failed: Steering Column. It is available for inspection. Safety or the safety of others put at risk: When driving the steering column will lock or stick into place until it is forced back into a normal driving position. This consistently occurs when driving on a corner or making slight steering adjustments on a straight road. Has the problem been reproduced by a dealer: UNKNOWN Has the vehicle or component been inspected: UNKNOWN Were there any warning lamps: None
Steering is "sticky" with a feel of detents in the steering instead of expected smooth engagement. At highway speeds this is concerning and feels unsafe. Difficult or impossible to steer smoothly.
The contact owns a 2004 BMW Z4. The contact stated while driving at various speeds in warm weather, the steering wheel was difficult to turn. The contact stated no warning light was illuminated. The contact was able to park on the side of the road. The contact continued driving with caution to his destination. The vehicle was not diagnosed or repaired. A dealer was not contacted. The manufacturer had not been informed of the failure. The failure mileage was approximately 125,000.
The the vehicle sits out in the sunlight or its warm outside (usually over 80F) the steering wheel will get very notchy and “stick” towards the center position at highway speeds. This makes minor steering corrections at highway speeds very difficult to make without unintentionally leaving your own lane possibly into another car. This is very much a safety issue! This has happened on multiple occasions since the week after I got it in May 2022. Tonight its only 65 degrees and it was acting up (this is 2 hours after sunset).
The steering wheel is "sticky" and has play in it when you are driving it. It appears to have steering drift. I feel this car is not safe to drive and is hard to control. No warning messages have come on. When I searched online, it appears that many others are having trouble with their 2004 z4 steering.
Presentate dai proprietari di questo anno modello e non verificate da NHTSA: il racconto di una persona, non un fatto accertato.
ON CERTAIN PASSENGER VEHICLES, UNDER CERTAIN ENVIRONMENTAL CONDITIONS, A VAPOR LOCK IN THE FUEL PUMP COULD OCCUR CAUSING THE ENGINE TO STALL. IF THIS WERE TO HAPPEN, THE ENGINE WOULD NOT BE ABLE TO BE RESTARTED FOR APPROXIMATELY 15 TO 20 MINUTES.
Rimedio: DEALERS WILL INSTALL A RESISTOR IN THE ELECTRICAL LINE POWERING THE FUEL PUMP IN ORDER TO PREVENT AN OCCURRENCE OF VAPOR LOCK. THE RECALL BEGAN MAY 11, 2004. OWNERS SHOULD CONTACT BMW AT 1-800-831-1117.
Pubblicati per anno modello, non per VIN: potrebbero non riguardare questo veicolo o essere già stati eseguiti. Verifica con un concessionario.
Water may come into contact with the starter relay and gradually cause corrosion. This could affect the electrical connection inside the relay and make the engine difficult to start. It may also result in a short circuit and could cause the starter to overheat leading to a fire when the vehicle is in motion or when it is parked with the ignition off. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The RSW22 starter with reinforced water tightness (RWT) may experience increased abrasion of the magnetic contact, causing deposits to build up at the lowest point inside the relay. These deposits may increase relay contact resistance, leading to starting failures or short circuits. If a short circuit occurs, either when attempting to start the vehicle or while driving due to vibration-related movement of the deposits, it could cause a thermal event and increase the risk of fire. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The failure concerns the RSW22 starter, type RWT (reinforced for watertightness). Increased abrasion of the magnetic contact can lead to the formation of deposits at the lowest point of the relay interior. This in turn can increase the resistance of the relay contact, causing accidental ignition or even short circuits, possibly leading to a thermal reaction and fire. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
Due to a manufacturing error, the weld seam of the integrated transmission control unit (ITCU) may not have been correctly executed. As a result, transmission oil could leak into the ITCU, causing it to fail. This may lead to transmission seizure, increasing the risk of an accident. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
Abbinati per marca e nome del modello: Safety Gate non pubblica il VIN. Controlla le date di produzione e cita il codice del richiamo al concessionario.