2016 BMW Z4
1 recall and 4 owner complaints on record for this model year.
Check a specific vehicle
This page describes the model. To see how one particular car is equipped, and whether its identifier is valid, decode its VIN.
Decode a VIN1 recall and 4 owner complaints on record for this model year.
This page describes the model. To see how one particular car is equipped, and whether its identifier is valid, decode its VIN.
Decode a VINAlmost all of this describes the model year, not the individual car. Nothing here can tell you about this vehicle’s mileage, accidents or ownership — no identifier encodes those.
BMW of North America, LLC. (BMW) is recalling certain 2012-2015 X1 sDrive28i, X1 xDrive28i, 2012-2016 Z4 sDrive28i, 528i, 528i xDrive, 328i, 328xi, 2016-2018 X5 xdrive 40e, 2014-2016 228i, 228xi, 428i, 428i xDrive, 328xi Gran Turismo, 2013-2017 X3 sDrive28i, X3 xDrive28i, 2015-2018 X4 xDrive28i, 2015-2016 428xi vehicles. An improperly sealed electrical connector on the water pump may be exposed to water and short circuit.
Remedy: Dealers will inspect and replace the water pump and plug connector as necessary, and install a protective shield, free of charge. Owner notification letters were mailed on March 28, 2025. Owners may contact BMW customer service at 1-800-525-7417.
Published by model year, not by VIN — may not apply to this vehicle, or may already have been done. Confirm with a dealer.
Water may come into contact with the starter relay and gradually cause corrosion. This could affect the electrical connection inside the relay and make the engine difficult to start. It may also result in a short circuit and could cause the starter to overheat leading to a fire when the vehicle is in motion or when it is parked with the ignition off. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The RSW22 starter with reinforced water tightness (RWT) may experience increased abrasion of the magnetic contact, causing deposits to build up at the lowest point inside the relay. These deposits may increase relay contact resistance, leading to starting failures or short circuits. If a short circuit occurs, either when attempting to start the vehicle or while driving due to vibration-related movement of the deposits, it could cause a thermal event and increase the risk of fire. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The failure concerns the RSW22 starter, type RWT (reinforced for watertightness). Increased abrasion of the magnetic contact can lead to the formation of deposits at the lowest point of the relay interior. This in turn can increase the resistance of the relay contact, causing accidental ignition or even short circuits, possibly leading to a thermal reaction and fire. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
Due to a manufacturing error, the weld seam of the integrated transmission control unit (ITCU) may not have been correctly executed. As a result, transmission oil could leak into the ITCU, causing it to fail. This may lead to transmission seizure, increasing the risk of an accident. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
Matched on brand and model name — Safety Gate publishes no VIN. Check the production dates, and quote the recall code to a dealer.
TL* THE CONTACT OWNS A 2016 BMW Z4. THE CONTACT STATED THAT WHILE HIS WIFE WAS STOPPED AND THE BRAKE PEDAL WAS DEPRESSED AN UNKNOWN NOISE WAS HEARD AS, THE VEHICLE ACCELERATED OUT OF CONTROL AND CRASHED INTO THE REAR OF THE VEHICLE IN FRONT CAUSING THAT VEHICLE TO CRASHED INTO THE VEHICLE AHEAD OF IT. THERE WERE NO WARNING LIGHTS ILLUMINATED. THE DRIVER'S SIDE FRONTAL AND KNEE AIR BAGS DEPLOYED. THE DRIVER SUSTAINED MINOR INJURY THAT REQUIRED MEDICAL ATTENTION. A POLICE REPORT WAS FILED. THE VEHICLE WAS TOWED TO AN AUTO BODY REPAIR FACILITY. THE CONTACT CALLED THE BMW OF TEMPLE DEALER (6006 S GENERAL BRUCE DR, TEMPLE, TX 76502) AND WAS TOLD TO CALL THE MANUFACTURER. THE MANUFACTURER WAS MADE AWARE OF THE FAILURE AS THE CONTACT WAS AWAITING THE REPORT FROM THE EVENT DATA RECORDER (EDR) AND A CASE WAS OPENED. THE CONTACT WAS CONCERNED AS HE WANTED THE CAUSE OF THE FAILURE TO BE DIAGNOSED BEFORE THE VEHICLE WAS RETURNED TO HM. THE FAILURE MILEAGE WAS APPROXIMATELY 8,000. THE VIN WAS NOT AVAILABLE.
The contact owns a 2016 BMW Z4. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The air conditioning system has a very very foul musty smell when you first start the vehicle after sitting for a few hours. It will go away after a few minutes, but the dealer nor repair shops can fix the issue. System was cleaned, new micro air filter was installed, but still have the musty odor. Even the a/c drain was cleaned, all to no avail. This seems to be a class thing with all BMW vehicles according to the many BMW owners I have spoken with. But no one can fix the problem.
ABOUT 20% OF TIME, DRIVER SIDE SEAT BELT JAMS, WILL NOT RELEASE FROM RECESS/RETAINER BEHIND SEAT WITHOUT USING MY HAND FOR COUPLE MINUTES TO JIGGLE ENOUGH. NO PROBLEM ONCE I GET IT TO RELEASE. THEN FITS IN CONNECTOR AND ALSO RELEASES OK. TWO LOCAL DEALERS UNABLE TO FIX. ONE EVEN REPLACED ENTIRE MECHANISM, STILL JAMS. MANAGER SAID THIS MODEL SEEMS TO HAVE THIS PROBLEM. THIS OCCURS AT A STAND STILL, BEFORE PUTTING CAR IN GEAR, SOMETIMES WITH MOTOR ON, SOMETIME BEFORE I START THE ENGINE. SOMETIMES JUST OPENING THE DOOR CAUSES THE RELEASE. OTHER TIMES, I HAVE TO PUT MY HAND UNDER THE BELT AND MANEUVER THE BELT UNTIL IT RELATES FROM THE RETAINER INTO WHICH THE BELT RETRACTS. NO PICTURES INCLUDED. JUST A STANDARD SEAT BELT. HAD A BMW 3351 FOR 7 YEARS. NEVER HAD THIS PROBLEM ONCE.
Filed by owners of this model year and unverified by NHTSA — one person’s account, not an established fact.