4 Rückrufe und 47 Halterbeschwerden für dieses Modelljahr erfasst.
Diese Seite beschreibt das Modell. Um zu sehen, wie ein einzelnes Fahrzeug ausgestattet ist und ob seine Kennung gültig ist, entschlüsseln Sie die FIN.
FIN entschlüsselnFast alles hiervon beschreibt das Modelljahr, nicht das einzelne Fahrzeug. Nichts davon sagt etwas über Laufleistung, Unfälle oder Eigentum dieses Autos — keine Kennung kodiert das.
The vehicle was traveling at highway speeds when it experienced a sudden, violent lateral jerk to the side, causing immediate side-curtain/seat airbag deployment prior to impacting the center divide. I believe there was a sudden, catastrophic mechanical failure of the front suspension componants causing a partial detachment of the front driver's side wheel. This failure mirrors the exact defect described in NHTSA Campaign 24V834000 / Mazda Recall 7925J regarding un-torqued front suspension fasteners. We believe our vehicle suffered from this exact factory build issue despite falling outside the initial recalled VIN list. Insurance claim to follow.
I previously reported the auto breaking system would slam on breaks prematurely. Now it was a factor in an accident where the Mazda CX-50 was rear-ended by a Ram 2500 truck at full speed on the highway. Car is incompaitated and I have suffered injuries.
Burns and scarring on my thigh from the heated seats
I was driving to Castle Rock, CO from Parkville, MO on [XXX] for vacation. I used the heated seat feature off and on during the trip. When I arrived in CO at my destination I noticed my thighs were hurting- stinging and hot. I checked my thighs and saw they were red and blisters were forming. I went to urgent care and I referred to the ER- I was given information about how to treat 2nd/3rd degree burns. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
TO NTSA - 2025 Mazda CX-50 Premium Turbo Plus - Purchased [XXX] - Less than 2,000 miles Driving north on [XXX] , I took exit [XXX] . When slowing to change to the right-hand lane, it surged then rapidly accelerated. Stepping on the brake did not slow it down, increased acceleration. To avoid hitting cars in my lane, I jumped the curb to the frontage road, continually pumping on the brake. The left front wheel and axle broke off and landed 20 ft away. The vehicle did not slow down; It was stopped by snapping a power pole in half. While trying to grab my purse, two Good Samaritans yelled at me to get out of the car, it was smoking and there were power lines overhead. Miraculously, I walked away. The Mazda salesman we purchased from was notified with photo. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
My child is able to pull the pads off of the car seat. This is so unsafe and should not be allowed to happen. She is only [XXX] old. I am unable to resume the pass to the car seat. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
The drivers side inside door handle has quit working twice. The dealer has temporarily fixed it both times, but advised us to "just be more gentle with the handle". The cable is falling off of the door hinge inside the door, and the dealer claims they don't have a way to permanently fix it. They just put it back on its mount. We are afraid that the driver will not be able to escape the vehicle in an emergency. Both instances have been under 10,000 miles. The door handle works perfectly fine until it doesn't work at all. No warning given.
The factory adhesive/anti-flutter sealant that bonds the outer hood skin to the inner structural frame has physically separated. There is a clear gap where the outer panel is no longer attached to the frame. As a result, the outer hood skin flexes and vibrates, especially at highway speeds. Impact / Safety Concern: The vibration and movement of the outer hood panel occurs directly in the driver’s forward line of sight. This creates a visible distraction while driving and can draw attention away from the road. Because the outer skin is no longer properly bonded to the structure, the condition is progressive and may worsen over time. Dealer Response: I documented the adhesive separation on the work order. The service advisor lowered the hood insulation and photographed the panel separation. Despite clear visual evidence, the technician closed the concern as “no issue with the hood insulation” and “no fault found.” The same separation was also observed on another CX-50 at the dealership. I am filing this report so the condition can be properly documented while the vehicle remains under warranty.
The automatic emergency braking in this vehicle is faulty. It misinterprets obstacles and uses the emergency braking inconsistently. I park in a parking garage and I have to slowly (less than 5 MPH) drive up any ramps because it apparently sees the ceiling of the garage as a obstacle and as a result, will randomly brake with no notice (which feels like getting rear ended). The dealer said it is working as designed and said I can turn this function off, but I have to turn it off every time I start the car. I also updated the sensitivity t the lowest setting, which didn’t help. I’m worried about this issue happening when I’m in traffic or bad weather and what might occur, like an accident. I’ve talked with other users of this same vehicle and they have ran into similar issues. Based on my experience, I think the system is defective and is a safety issue.
"My 2025 Mazda CX-50 began overheating while still under the factory warranty. During one incident, the engine lost coolant and overheated. I immediately shut the engine off to prevent damage. The vehicle continues to overheat, and the air conditioning only cools properly while the vehicle is moving. When stopped or idling, the A/C stops cooling. I have reported the issue to my Mazda dealer and opened Mazda Customer Experience Case Number 00473077. The problem remains unresolved despite multiple attempts to obtain assistance. I am concerned this condition presents a safety risk." "The vehicle has been inspected by an authorized Mazda dealership on two separate occasions. The dealership kept the vehicle for several days during these inspections but reported that it could not reproduce or identify the cause of the overheating. Despite these inspections, the overheating condition and the air conditioning issue continue. During one of the service visits, I also discovered scratches to the vehicle's exterior that were not present before it was left with the dealership."
While driving my 2025 Mazda CX-50, the entire center-dash climate control panel (HVAC module) suffered a sudden, spontaneous, and total electrical power blackout. The unit completely loses power and goes dark exactly as if the power button was pressed. This is a recurring failure that occurs after only a few minutes of vehicle operation. This electrical failure immediately cuts all airflow and A/C cooling to the cabin. The unit can temporarily be turned back on manually, only to black out and fail completely again minutes later. This represents my second consecutive modern Mazda vehicle to experience an early-mileage HVAC hardware/electrical failure (previously a CX-30), indicating a dangerous, recurring manufacturing defect in Mazda’s electrical/climate control architecture that requires a formal safety recall. Additional Considerations: Distraction and Loss of Driver Focus, Rapid Window Fogging and Blindness, Extreme Heat Exhaustion and In-Cabin Medical Emergency, and Broader Electrical Fault Concerns.
Brake booster failure in less than two years of ownership. It seems to be an issue with A LOT of these models. Very unsafe to have any brake failure
CRUISE CONTROL SURGES BEYOND NORMAL LIMITS, HAS TRIED TO TAKE CURVES ON EXITS SO FAST THE TIRES SLIDE AND I HAVE TO SLAM ON THE BRAKES. ALSO, WHEN PULLING OUT FROM BEHIND A CAR, THE CRUISE CONTROL KICKS IN TOO FAST AND IS FLYING TOWARD STOPPED CARS, AND I HAVE TO USE THE BRAKE TO STOP IT OR REAR-END THE CAR IN FRONT OF ME. ALSO, THE FUEL SYSTEM WOULD NOT ALLOW ME TO FILL UP THE GAS TANK, AND I WAS STRANDED. COMPUTER WOULD NOT OPEN THE FUEL TANK FOR ME TO PUT FUEL INTO IT. HAS TO PRY THE ENTIRE ASSEMBLY OFF AND BREAK IT. THEN FUEL WOULD NOT GO INTO THE FUEL TANK, AIR PRESSURE KEPT TURNING OFF THE PUMP. AFTER THOSE INCIDENTS GOT THE CAR BACK FROM THE DEALER AND TWO DAYS LATER IT WAS COMPLETELY DEAD IN THE GARAGE, NOTHING WORKED, LOCKS, BACK LATCH, ETC. WHEN THEY RECARGED IT THERE WERE DOZENS OF CODES ON.
When approaching cars at an intersection, the brake warning does not give any warning, but the cars brake, lock up, and throw me and anything in the seat flying into the floor or side compartment. It was not even necessary to stop that quickly. Totally random and could cause an accident.
I rented this vehicle from Enterprise (EAN HOLDINS LLC) in Collierville Tn. on 5/19/25 I rented the vehicle to attend a funeral in Virginia. I drove 1803 miles there and back. While it was raining and cold, I used the seat heaters on and off when I noticed that my legs and gluts began to become irritated and inflamed. Once I finally was home late that night, I observed that I had been burned on legs and glut area. The areas were red and inflamed. That morning I had blisters and large red/purple bruises which I began documenting with photos. I went to see my doctor who stated that I had 1st and 2nd degree burns which he then photographed and documented in my chart and prescribed some meds. Today the areas are still numb but appear to be healing. I did report this incident to Enterprise locally and I also made a complaint with the company's corporate office 1800 numbers. These car seat heaters are extremely dangerous
Von Haltern dieses Modelljahrs eingereicht und von der NHTSA nicht geprüft — die Schilderung einer Person, keine feststehende Tatsache.
Mazda North American Operations is recalling certain 2025 CX-50 and CX-50 Hybrid vehicles. The front suspension fastener bolts may not be tightened properly, which can result in suspension component and/or wheel detachment.
Abhilfe: Dealers will inspect the front suspension fastener bolts and, if necessary, replace and tighten them, free of charge. Owner notification letters were mailed December 10, 2025. Owners may contact Mazda customer service at 1-800-222-5500 Option 6. The manufacturer's number for this recall is 7925J. Vehicle Identification Numbers (VINs) involved in this recall became searchable on NHTSA.gov beginning November 3, 2025.
Mazda North American Operations (Mazda) is recalling certain CX-50 Hybrid and CX-50 vehicles. Incorrectly configured module software may cause the air bag to deploy improperly.
Abhilfe: Dealers will update the module software, free of charge. Owner notifications will not be mailed due to all vehicles being under Mazda dealer control. Owners may contact Mazda customer service at 1-800-222-5500 Option 6. The manufacturer's number for this recall is 7625F.
Mazda North American Operations (Mazda) is recalling certain 2024-2025 CX-50 vehicles equipped with Mazda Genuine Accessory trailer hitches. The trailer hitch assembly bolts may loosen and cause the assembly to separate from the vehicle body during towing or normal driving conditions.
Abhilfe: Dealers will tighten the trailer hitch bolts, free of charge. Owner notification letters were mailed April 4, 2025. Mazda's number for this recall is 7225C.
Mazda North American Operations (Mazda) is recalling certain 2024 Mazda 3, CX-30, and 2025 CX-50 vehicles. A malfunction in the forward sensing camera (FSC) may prevent the automatic emergency braking system and the lane-keep assist system from functioning. In addition, the headlights will not automatically adjust from high beams to low beams as intended.
Abhilfe: Dealers will inspect and replace the forward sensing camera as necessary, free of charge. Owner notification letters were mailed September 24, 2024. Owners may contact Mazda customer service at 1-800-222-5500, Option 6. Mazda's number for this recall is 6824H.
Nach Modelljahr veröffentlicht, nicht nach FIN — betrifft dieses Fahrzeug möglicherweise nicht oder wurde bereits erledigt. Beim Händler bestätigen.